Canon Color imageCLASS MF8280Cw, Service Manual

Page: 356 / 401

8
8
8-8
8-8
Service Mode > COPIER > ADJUST > ADJ-XY
Service Mode > COPIER > ADJUST > ADJ-XY
COPIER > ADJUST > ADJ-XY M82 M85
ADJ-Y-DF Adj img pstn in ADF mode:horz scan
○ ○
Details To adjust the image reading start position in the horizontal
scanning direction at ADF reading.
When replacing the Engine Controller PCB/clearing the
RAM data, enter the value of service label.
As the value is incremented by 1, the image position
moves to the trailing edge side by 0.1 mm.
Use case • When replacing the Reader Unit
• When replacing the CIS Unit
Adj/set/operate method Enter the setting value (switch negative/positive by -/+
key) and press OK key.
Caution After the setting value is changed, write the changed
value in the service label.
Display/adj/set range -10 to 10
Unit 0.1 mm
Default value 0
ADJ-X-MG Fine adjustment of image magnification ratio (vertical
scanning direction)
○ ○
Details To make a fine adjustment of image magnification ratio
in the vertical scanning direction by changing the reading
cycle of CIS.
When replacing the Engine Controller PCB/clearing the
RAM data, enter the value of service label.
As the value is incremented by 1, the image magnification
changes by 0.01 %.
+: Reduce
-: Enlarge
Use case When replacing the Engine Controller PCB/clearing RAM
data
Adj/set/operate method Enter the setting value (switch negative/positive by -/+
key) and press OK key.
Caution After the setting value is changed, write the changed
value in the service label.
Display/adj/set range -200 to 200
Unit 0.01 %
Default value 0
COPIER > ADJUST > ADJ-XY M82 M85
STRD-POS Adjustment of reading position at ADF stream reading
○ ○
Details To adjust the reading position at ADF stream reading.
When replacing the Engine Controller PCB/clearing the
RAM data, enter the value of service label.
Use case When replacing the Engine Controller PCB/clearing RAM
data
Adj/set/operate method Enter the setting value (switch negative/positive by -/+
key) and press OK key.
Caution After the setting value is changed, write the changed
value in the service label.
Display/adj/set range -20 to 20
Unit 0.1 mm
Default value 0
Related service mode COPIER> FUNCTION> INSTALL> STRD-POS
T-8-6