Can-Am SPYDER F3TM 2016, Operator'S Manual

Page: 108 / 171

MAINTENANCE PROCEDURES
rmo2015-008-200_a
A. 10 m (33 ft)
90°
rmo2015-008-201_a
3. Trace 2 lines parallel to the ground
on the test surface as follows:
LINES ON THE TEST SURFACE
Line A
644 mm (25-23/64 in)
above ground
Line B
554 mm (21-13/16 in)
above ground
4. Have driver take place on the
driver's seat.
5. Select low beam.
6. Beam aiming is correct when the
top line of the headlight reflection is
between the marks.
rmo2015-008-778_a
TYPICAL - HEADLIGHT REFLECTION ON
TEST SURFACE (SINGLE HEADLAMP)
1. Top line
A. Mark at 644 mm (25-23/64 in) above ground
B. Mark at 554 mm (21-13/16 in) above ground
Headlights Aiming Verification
(European, Australian and Japanese
Models)
1. Verify tires are correctly inflated.
Refer to
SPECIFICATIONS
.
2. Position vehicle 10 m (33 ft) in front
of a test surface as shown. Make
sure vehicle is on leveled ground.
rmo2015-008-200_a
A. 10 m (33 ft)
90°
rmo2015-008-201_a
3. Trace 4 lines parallel to the ground
on the test surface as follows:
LINES ON THE TEST SURFACE
Line A 688 mm (27-3/32 in)
Line B 618 mm (24-21/64 in)
Line C 564 mm (22-13/64 in)
Line D 514 mm (20-15/64 in)
4. Have driver take place on the
driver's seat.
5. Select high beam.
6. Beam aiming is correct when the
focus point (brightest spot) of the
headlight reflection is between the
upper marks.
106
______________