Can-Am SPYDER F3TM 2016, Operator'S Manual

Page: 100 / 171

MAINTENANCE PROCEDURES
NOTE: Engine oil level verification
must be performed within 2 minutes
after engine stop.
5. Remove RH lateral service cover.
Refer to
BODY PANELS
.
6. Unscrew and remove the oil dip-
stick.
rbl2015-006-522_a
TYPICAL
1. Oil dipstick
7. Wipe off the dipstick.
8. Reinsert and completely screw in
the dipstick.
9. Unscrew and remove the dipstick
again.
10. Check the oil level on the dipstick.
rmr2014-011-080_a
1. MAX
2. MIN
3. Operating range, 0.5 L (.5 qt (U.S. liq.))
Oil Level between Lower (MIN) and
Upper (MAX) Marks:
1. Do not add oil.
2. Properly insert and tighten dipstick.
3. Install RH lateral service cover.
Oil Level under MIN Mark
Adjustment:
1. Add approximately 500 ml
(17 U.S. oz) of recommended
oil.
NOTE: The oil quantity between MIN
and MAX marks is 500 ml (17 U.S. oz).
2. Restart the engine and let it idle for
10 minutes.
WARNING
Exhaust gas contains poisonous
carbon monoxide that can rapidly
accumulate in an enclosed or
poorly ventilated area. If inhaled,
it can cause serious injury or
death. Only run the engine in an
unenclosed, well ventilated area.
NOTICE
Adjusting the oil level on
a cold engine will result in overfill-
ing.
3. Stop the engine.
NOTE: Engine oil level verification
must be performed within 2 minutes
after engine stop.
4. Recheck oil level.
5. Repeat the above steps until oil
level reaches the dipstick between
the lower and upper marks.
Do not
overfill.
6. Properly insert and tighten dipstick.
7. Install RH lateral service cover.
Changing the Engine Oil and Oil
Filter
1. Prior to changing the oil, ensure ve-
hicle is on a level surface.
NOTICE
The engine oil and the en-
gine oil filter must be replaced at the
same time. The oil change should
be carried out with a warm engine.
98
______________