Camus Hydronics Valiant-FT II Series, Installation And Service Manual

Page: 30 / 64

26
Outdoor Sensor Connected to Slave Boiler 2
Description Electrical Connection(s) Programming Instructions
•
Slave boiler outdoor
sensor configuration
•
Outdoor temperature
sensor must be
connected to boiler
#2.
•
When done correctly,
the outdoor
temperature will be
shown on the Master
boiler
Slave Boiler
1) Press and
2) Press Sensor Configuration
3) Select S5 (J8-11) Sensor
4) Select Connector type = 10K single non-safety
5) The control will proceed into a Lockout 2 condition
6) Press [Verify] > [Begin] > [Yes]
7) Press the reset button on the ignition control within the alotted time
Master Boiler
8) Press and
9) Press [Lead Lag Master Configuration]
10) Press [Advanced Settings >]
11) Press the to arrive at Outdoor Reset
12) Select Enable: Enabled
13) Select Maximum outdoor temperature (WWSD)
14) Select Minimum outdoor temperature (Outdoor design)
15) Select Low Water Temperature (Min. water temp)
16) Select Outdoor boost maximum off point (Design max.)
17) Press [Show Line] to confirm reset curve
18) Press the to arrive at Warm Weather Shutdown
19) Select Enable = Shutdown after demand ends