Camus Hydronics Valiant-FT II Series, Installation And Service Manual

Page: 24 / 64

20
Hydronic Heating
Modulation: Boiler Outlet, Boiler Fixed Setpoint Operation (Standalone)
Description Electrical Connection(s) Programming Instructions
•
Boiler operates at a
fixed CH setpoint
•
Modulates on boiler
outlet sensor
(default)
•
Heat demand is
generated when
outlet temperature
drops below setpoint
minus on hysteresis
•
If set to local enable
constant pumping is
required
•
For remote enable
intermittent pumping
is allowed.
1) Place toggle switch to LOCAL
2) Press and
3) Press [CH
– Central Heat Configuration]
4) Press the to arrive at Setpoint
5) Select Setpoint source: Local
6) Enter desired Setpoint
7)
Place toggle switch to REMOTE for remote enable operation (if
required)
Modulation: Boiler Outlet, Outdoor Reset Operation (Standalone)
Description Electrical Connection(s) Programming Instructions
•
Boiler operates with
variable setpoint
determined by
outdoor reset curve
•
Modulates on outlet
sensor (default)
•
Heat demand is
generated when
outlet temperature
drops below setpoint
minus on hysteresis
1) Connect outdoor sensor to System/Outdoor contacts
2) Place toggle switch to LOCAL
3) Press and
4) Press Outdoor Reset Configuration
5) Select Enable: Enable
6) Select Maximum outdoor temperature (WWSD)
7) Select Minimum outdoor temperature (Outdoor Design)
8) Select Low Water Temperature (Min. Water Temp.)
9) Select Outdoor boost maximum off point (Design Max.)
10) Press [CH
– Central Heat Configuration]
11) Select Outdoor Reset = Enabled
12) Set CH Setpoint = Outdoor boost maximum off point
13) Press Sensor Configuration
14) Select Outdoor temperature source = S5 (J8-11) sensor
15)
Place toggle switch to REMOTE for remote operation (if required)