9
FRONT TRACK SYSTEM
INSTALLATION
1. Remove front wheels. Make sure that wheel studs
and wheel hubs are free of dirt.
2. If applicable, remove CV joint protectors.
3. Remove bolts, nuts, washers, and bushings from
front stabilizing rod ends. See Fig. 16
Fig. 16
4. Insert bolt in rear anchor bracket (
A1
) as shown in
Fig. 17
CAUTION: Make sure that the bolt is inserted in the
right direction. See Fig. 18
Fig. 18
5. Position bottom part of anchor bracket (
A1
) under
lower suspension arm. Position top part (
A2
) over
suspension arm and insert tenon in mortise cut in
bottom part. Refer to Fig. 19
Fig. 19
6. Insert the M10x50 mm bolts (
A3
) from the bottom
and secure the two parts together with the nuts (
A4
)
provided. Tighten assembly to 50 N•m [37 lb•ft] of
torque. See Fig. 20
Fig. 20
7. Install wheel spacers (
E
) on rear hubs. See Fig. 21
RTV- X 900 | 1100 | 1120
