3
CamRanger Hardware
The CamRanger device is turned on by sliding the
power switch, located on the side of the unit,
towards the front of the device. The green power
light will illuminate when the unit is powered on.
Any additional switch present on the
CamRanger currently serves no function.
The charging port is located next to the power switch. The male micro B end of the provided
white charging cord is connected to this port. The other end of the charging cord can be
connected to a female USB port that provides power, such as a computer or through the
provided AC adapter.
When the device is charging, an additional yellow light will illuminate next to the green power
light indicating that it is charging. The yellow light will turn off leaving only the green power
light when it is fully charged.
The CamRanger battery is accessible by removing the bottom cover. The bottom cover is the
side with the CamRanger serial number. Simply grasp the side edge/corner of the cover near
the USB connector and pull back to remove. To replace
the
cover, first place the two lower tabs into the slots and
then
snap in the top.
CamRanger is not water-‐resistant in any way and should not get wet.
A black neoprene case is provided to assist in attaching and securing the CamRanger, note that
this pouch is not waterproof. The case has a carabineer to facilitate hanging from a tripod, belt
loop, etc. Do not just hang the CamRanger by the cable as it will put strain on the USB
connectors as well as possibly disconnect.
