Electro-pneumatic Regulator ER100
Instruction Manual
rev. 2.0
page 6 / 38
•
When the secondary side control pressure is used with the port left
open (in applications using nozzles for blowing etc.), pressure
fluctuations may occur depending on the piping conditions and the blow
conditions. Though it requires some extra efforts, please either verify
via testing using the actual use conditions or consult Camozzi.
•
When selecting a dryer, air filter, oil mist filter or regulator, select a
device with a flow rate higher than that used by proportional pressure
controls.
•
Operating environment
・
Avoid operating the product in places where it may be affected by direct
sunlight, water or oil.
For operation in other than the specification requirements or for special
purposes, please contact Camozzi.
•
Drip-proof environment
・
The protective structure of this product is equivalent to that of
the IP40.
Do not install this product at places where exposed to
moisture, salt, dust or chips or under positive or negative pressure. Do
not operate at places with steep temperature fluctuations or in high
humidity because dew condensation inside the main body will cause
problems.
•
With this product, even if the pressure is set to 0 bar, the secondary
pressure is not completely released. It remains at a value less than 1%
of F.S. of maximum control pressure. If 0 Bar is required, bleed the
secondary side, or install a 3/2-way valve on the secondary side to
switch to atmosphere, etc.
!
CAUTION
:
