Camozzi CX06 Series, Operation And Maintenance Instruction

Page: 25 / 27

Operation and maintenance instructions
CPU PROFINET Series CX06 module
5000004825
Versione 01
53
Blinking
Function “node blink test” activeted by
controller (PLC) Data exchange don’t work because
some settings are not admitted
Led 2 (LINK1) Led 1 (LINK2)
Fixed
The IN port isn’t connected to network The IN port isn’t connected to network
Fixed
The IN port is connected to network The OUT port is connected to network
Blinking
The IN port receive/send Ethernet
frame The OUT port receive/send Ethernet
frame
10. Limitations on use

Never exceed the technical specifications stated in the paragraph "General characteristics"
and the Camozzi general catalogue.

Do not install the product in environments where the air itself may generate hazards.

With the exception of specific intended applications, do not use the product in environments
where there is the risk of direct contact with corrosive gas, chemical products, salt water,
water or steam.
11. Maintenance
 If performed incorrectly, maintenance may impair efficient operation of the product and
harm persons in the vicinity.

Check all conditions to prevent the inadvertent release of parts, and disconnect the power
supply to enable the discharge of residual pressure from the system before performing work.

Check whether it is possible to have the product serviced at a technical assistance centre.

Never disassemble units when electrically powered.

Shut off electric supplies before maintenance.

Always remove accessories before maintenance.

Always wear the correct personal protective equipment as envisaged by local authorities and
in compliance with current legislation.

In the event of maintenance, replacement of worn parts, use exclusively the original Camozzi
kits and ensure that operations are only performed by specialized and authorized personnel.
Otherwise product approval will be rendered invalid.