Operation and maintenance instructions
CPU PROFINET Series CX06 module
5000004825
Versione 01
40
To improve immunity to disturbance and prevent damage, it is recommended to connect
the device to the circuit earthing system using any one of the holes on the aluminium body.
In order to connect the CPU module to ProfiNet bus, is reccomended to use a CAT5 complies
with specification.
The ProfiNet segment maximum length is 100 mt. If it is necessary to exceed the maximum
lengths indicated below, you must to use repeater.
For configuration of the CPU module and the connected modules, download the set-up file
of the software
CX-Configurator
from the web site
http://www.camozzi.com
and proceed
with installation according to the instructions on screen displayed during the process. For
more details, please refer to the
"Operating and Maintenance Instructions - CX
Configurator"
.
In order to configure the CX06 CPU module with a programmer/PC it is necessary to use the
archive GSDML-V2.31-Camozzi-CX-20160111.xml. In addition to the slave characteristic data
(ID Number, revision, etc.), the GSDML file contains the identifiers of the modules that are
used for the hardware configuration of the PLC. The GSDML file of the CPU module can be
downloaded from the website Camozzi.
On the GSDML file, the following modules are descripted. Use these modules on the
programmer/PC in order to realize the CPU module HW configuration.
Module description
Input bytes used on the PLC memory
Output bytes used on the PLC
memory
1 Byte In
1
0
1 Byte Out
0
1
2 Byte In
2
0
2 Byte Out
0
2
4 Byte In
4
0
4 Byte Out
0
4
8 Byte In
8
0
8 Byte Out
0
8
16 Byte In
16
0
16 Byte Out
0
16
32 Byte In
32
0
32 Byte Out
0
32
