Cameron Opti-Rip 415A-M1, Manual

Page: 57 / 76

57
TROUBLESHOOTING
TROUBLESHOOTING
#415-R1
8-15-18 - JR
Diagnostics - Inputs and Outputs
Selecting "Inputs and Outputs" from the "Diagnostics" menu opens the Inputs and Outputs
window. This window can be used to test various inputs and outputs.
Inputs
The items displayed on the left hand side
of the window are the values for the inputs.
When the buttons are pressed, or the inputs
are activated, these values should read 1,
otherwise they should read 0.
The Length Count represents a counter
value for the optical encoder located on the
pinch roller. When the pinch roller is rotated
in either direction, this counter should count
up.
The Width Count counts when the belts are
moved. This should count up when the belts
move a board toward the saw and down when moving away from the saw.
The width sensors each show three values. The first value changes from 0 to 1 whenever
the beam is broken. The remaining values are the servo counter values for the leading and
trailing edge of the most recently measured board.
Outputs
Outputs can be energized by pressing keys on the keyboard. Pressing the key causes the
corresponding output to be toggled on and off again. These are listed on the right hand
side of the window.
In addition, the belts can be activated by pressing the A key. When the A key is pressed,
the belts should move exactly 24 inches. When the A key is pressed a second time, the
belts should move exactly 24 inches in the opposite direction.