Cameron Opti-Rip 415A-M1, Manual

Page: 62 / 76

62
TROUBLESHOOTING
TROUBLESHOOTING
#415-R1
8-15-18 - JR
Light Curtain Alignment and Adjustment
If you are having issues with the light curtain on your Opti-Rip, follow the steps below:
1) Place the optic windows as much inline as possible. Alignment between the axes of the
two elements must not exceed ±1.5°.
2) Power on the system. The green LED’s will turn on, indicating that the power is correct.
Turn the trimmer on the emitter (see below) all the way clockwise. The red LED on the
emitter will have to be switched off, indicating the presence of the correct synchronism.
3) Correct the direction of the emitter by observing the red LED on the receiver and trying
to find the position in which the LED completely switches off or shows a weak light. Then
temporarily fix the emitter in this position.
4) Correct the direction of the receiver by observing its red LED until it is completely
switched off or shows a weak light. Then temporarily fix the receiver in this position.
5) Repeat points 3 & 4 until when you reach alignment.
**It's important to take note of the following
items:
-The RED LED on the receiver lights
proportionally to the signal received and
remains turned off when the signal is
optimum.
-Do not allow dust, water or condensation to
deposit on the optics.
-Avoid exposing optics to organic solvents.
To clean, use a damp rag and dry thoroughly.
-Do not allow strong light or sunlight to fall
directly onto the optics of the receiver.
Remove this cap
to adjust trimmer