Cameo S2 IP, User Manual

Page: 27 / 236

27
DMX
DEUTSCH
FRANCAIS
ESP
AÑOL
ENGLISH
IT
ALIANO
POLSKI
SYSTEM INFORMATION (System Info)
Starting from the main display, press the right-hand rotary-push encoder to access the menu for
selecting the operating mode (Menu). Turn the left encoder (SELECT) to select
System Info (note
the selection arrow on the left) and confirm by pressing the left encoder (ENTER).
This takes you to the submenu for calling up the system information (see table, selection by
turning the left encoder).
System Info
Main CPU Vx.xx
DRV CPU Vx.xx
LED Temp. xx°F xx°C
Op. Hours xxxxx:xx h
Display Always On / Off after 20s
Signal Fail Hold / Blackout / User Colour 8 / Fade Out 10s
Dim Curve Linear / Exponential / Logarithmic / S-Curve
Dim Response LED / Halogen
Red Shift Off / Dim to Warm
PWM 650Hz / 1530Hz / 3600Hz / 12kHz / 18.9kHz / 25kHz
Calibr. RAW / User / Factory / Smart
User calibration R= 000–255
User calibration G= 000–255
User calibration B= 000–255
User calibration W= 000–255
Auto Lock Off/On
Fan Auto / Off / Constant Low / Constant Medium / Constant High
WDMX Off/On
User Button 1
EZ Remote / Mode Selection / HSI / Direct / Colour Coordinates
GEL / User Colour / Play Loop / Light Simulation
User Button 2
EZ Remote / Mode Selection / HSI / Direct / Colour Coordinates
GEL / User Colour / Play Loop / Light Simulation
RDM UID xx xx xx xx xx xx
MAC Addr. xxx.xxx.xxx.xxx.xxx
In order to be able to access all menu items in the fixture with the help of the Cameo
UNICON DMX/RDM controller via Fixture Menu, the menu items
Stand Alone (with all
Stand Alone operating modes), EZ Remote and Slave are additionally located in the
main menu in addition to the Mode menu.