Cameo S2 IP, User Manual

Page: 16 / 236

16
DMX
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
DEUTSCH
ENGLISH
W-DMX
™
STATUS
W-DMX
deactivated
W-DMX
as receiver
activated,
not paired
W-DMX
as receiver
activated
and
paired,
Transmitter
switched off
or out of
range
W-DMX
as receiver
activated
and
paired,
no
DMX signal
W-DMX
as receiver
activated
and
paired,
DMX signal
is present
W-DMX
as trans-
mitter
with G3
standard
activated,
DMX signal
is present
W-DMX
as trans-
mitter
with G4s
standard
activated,
DMX signal
is present
W-DMX
as trans-
mitter
with G3
standard
activated,
no
DMX signal
W-DMX
as trans-
mitter
with G4s
standard
activated,
no
DMX signal
SETTING DMX START ADDRESS (DMX address)
Starting from the main display, press the rotary-push encoder to enter the main menu. Turn the
left encoder (SELECT) to select the menu item
DMX Address (note the selection arrow on the left)
and confirm by pressing the encoder (ENTER). You can now configure the DMX start address as
required by rotating the encoder (the highest value depends on the selected DMX mode). Confirm
the entry by pressing the left encoder (ENTER), this also automatically takes you back to the main
display and the DMX operating mode is activated. At the same time, the DMX start address follo-
wing the selected start address plus the channel number of the selected DMX mode is displayed
(Next Free Address). The menu item for selecting the desired DMX mode can be reached directly
from the menu item DMX
Address by pressing the middle rotary-push encoder (DMX mode); the
previously set DMX start address is automatically saved.
CONFIGURING DMX MODE (DMX Mode)
Starting from the main display, press the rotary-push encoder to enter the main menu (MENU).
Turn the left encoder (SELECT) to select the menu item
DMX Mode (note the selection arrow on
the left) and confirm by pressing the left encoder (ENTER). Now you can select the desired DMX
mode by turning the left encoder. Confirm the selection by pressing the left encoder (ENTER), this
also automatically takes you back to the main display and the DMX operating mode is activated.
The menu item for setting the desired DMX start address can be reached directly from the menu
item DMX
Mode by pressing the middle rotary-push encoder (DMX Address); the previously
selected DMX mode is automatically saved. Tables with the channel assignment of the different
DMX modes can be found in these instructions under DMX CONTROL.
ENABLE EXTERNAL CONTROL VIA DMX, ARTNET AND SACN
Starting from the main display, press the left-hand rotary-push encoder to access the menu for
selecting the operating mode. Turn the left encoder (SELECT) to select
DMX (note the selection arrow
on the left) and confirm by pressing the left encoder (ENTER). Now the control protocol that was
preselected in the menu item
Protocol in the main menu is activated (DMX512 / Artnet / sACN).
To configure the two control protocols Artnet and sACN as desired, press the right encoder (Menu),
then select
Protocol and confirm (Enter). Select the desired protocol, confirm, now select the
submenu items for setting and confirm again (see table).