+
_
p.
1
1
11
- M
an
u
al c
o
d
e:
3
1
9
W
7
6
31
9
W
76
v.
11
0
6
/2
0
1
4 © C
A
M
E S
.p
.A
. - T
h
e d
at
a a
n
d i
n
fo
rm
at
io
n i
n t
h
is m
an
u
al m
ay b
e c
h
an
g
ed a
t a
n
y t
im
e a
n
d w
it
h
ou
t n
ot
ic
e.
Adjusting the features
Trimmer
Description of features
A.C.T.
Automatic closing time
It adjusts the gate wait time when open. Once this time has elapsed, an automatic closing takes place.
The wait time can be adjusted to between 1 and 180 seconds.
APP./O.T.
The final resting point (encoder enabled) or working time (encoder disabled)
It adjusts the motors fi nal resting point before the opening and closing endstops.
The starting fi nal resting point is calculated as a percentage of the gate leave's complete travel, from 1% to 10%.
With encoder disabled, the trimmer is used for adjusting the working time from 5 to 120 seconds.
2M DELAY
M2 closing delay time
After a closing command or after an automatic closing, the leaf of gearmotor (M2) starts with a delay compared to
gearmotor (M1) for an adjustable time of between 3 and 25 seconds.
SPEED
Travel speed
It adjusts the speed of the gearmotors during the manuevers.
The speed may be adjusted from 30% (-) to 100% (+)
With disabled encoder and timed slow downs, the maximum speed is limited to 50%.
SLOW
Slow-down speed
It adjusts the gearmotors' speed when slowing down.
The speed may be adjusted from 30% (-) to 60% (+) of the maximum speed.
If the slow down speed is greater than the travel speed, the travel speed is automatically limited.
SENS.
Sensitivity
It adjusts the obstruction detection sensitivity during the gate movement.
Minimum sensitivity (-) or maximum sensitivity (+).
After adjusting the trimmers, select the DIPs and press the PROG key on the board as shown in features
programming.
Warning LED
LED
Description
PWR
(Green)
It warns about the voltage present in the control board
PRG
(Red)
It warns about the features' programming phases, the automatic closing waiting time and of any errors/
malfunctions
1
(Yellow)
It warns that contact 1-2 (NC) is open (STOP button)
3P
(Yellow)
It warns that contact 2-3P (NO) is closed (partial opening button)
7
(Yellow)
It warns that contact 2-7 (NO) is closed (command button)
C1/ON
(Yellow)
It warns that contact 2-C1 (NC) is open (photocells) / Feature enabled
CX/OFF
(
Yellow)
It warns that contact 2-CX (NC) is open (photocells) / Feature disabled
