2. Press the composite keys
[Shift]+[P-Set]
(System) to enter into the system
menu interface.
3. Use left and right keys or rotate the knob to select
I/O Config
and press
[Enter]
key to confirm.
4. Use left and right keys or rotate the knob to select
USB
and press
[Enter]
key to enter the usb setting menu.
5. Use left and right keys or rotate the knob to select
TMC
or
VCP
, after select
and press
[Enter]
to confirm.
•
TMC: USB_TMC interface
•
VCP: virtual serial port. Select this type, you need to install the
corresponding driver (download from the ITECH website or contact
ITECH agent). The device manager of PC will display ‘Prolific USB-to-
Serial COM Port’ after installing.
6. After finishing the setting, press
[Esc]
to exit.
2.6.2 GPIB Interface
When the optional interface card is a GPIB interface (IT-E1205), you need to
know the following.
Each device on the GPIB (IEEE-488) interface must have a unique number
address between 0 and 30. Your computer’s GPIB interface card address must
not conflict with any instrument on the interface bus. This setting is nonvolatile;
it will not be changed by power cycling or *RST. The figure below shows a
typical GPIB interface system.
You can change the GPIB address in the system menu. The operation steps
are as follows.
1. Refer to the GPIB connection diagram, Connect the power supply and the
computer using a IEEE-488 bus.
2. Press
[Shift]+[P-Set]
(System) to enter into the system menu interface.
3. Use left and right keys or rotate the knob to select
I/O Config
and press
[Enter]
key to confirm.
4. Use left and right keys or rotate the knob to select GPIB and set GPIB
Address, press
[Enter]
key to confirm.
Copyright © Itech Electronic Co., Ltd.
25
