CAEN
Electronic Instrumentation
UM3148
–
DT5730/DT5725 User Manual rev. 2
52
12
HW Installation
Power-on Sequence
To power on the board, follow the procedure below:
1.
connect the 12V DC power supply to the DT5730/DT5725 through the DC input rear connector;
2.
power up the DT5730/DT5725 through the ON/OFF rear switch.
See §
Rear Panel
to identify the relevant components
Power-on Status
At power-on, the module is in the following status:
•
the Output Buffer is cleared;
•
registers are set to their default configuration.
After the power-on, the front panel LEDs status is that only the NIM and PLL LOCK remain ON (see
Fig. 12.1)
.
Fig. 12.1:
Front panel LEDs status at power ON
AFTER POWER-ON, CAEN RECOMMENDS TO PERFORM THE CHANNEL CALIBRATION AS DESCRIBED AT PAGE 22 IN
ORDER TO ACHIEVE THE BEST DEVICE PERFORMANCE