![background image](http://html1.mh-extra.com/html/cactus/v6-ii/v6-ii_manual_3228642030.webp)
3. Mount one of the V6 II RXs onto the camera’s hot shoe, and also connect the V6
II RX to the camera’s shutter release port with an appropriate shutter release
cable (optional). Connect the other V6 II RXs to the flash units.
4. On the on-camera V6 II RX, press . Turn the selection dial to <RELAY>.
Press .Turn the selection dial to <ON>. Press to confirm and then press
to return to the main screen. The relay mode indicator <REL-C> will appear on
the main screen.
5. In the handheld V6 II TX unit, press . Turn the selection dial to <RELAY>. Press
and turn the dial to <ON>. Press , then press to return to the main
screen. The relay mode indicator REL will replace the channel indicator.
(image)
6. By pressing on the TX, both the camera and flash units will be triggered and
sync with each other. In addition, you will also be able to control the power level of
the flashes with your V6 II TX.
7. To exit the Relay mode in both TX and RX units, press and turn the selection
dial to <RELAY>. Press and turn the selection dial to <OFF>. Press and then
press to return to the main screen.
16.Advanced Operations
16.1 Autofocus Assist Light
The V6 II is equipped with an autofocus assist LED and is capable of supporting the
auto-focus assist signal from configured camera system. The power of the LED light
could be adjust to best suit your working environment.
To configure the AF assist LED:
1. Switch on the V6 in TX or RX mode, press , and turn the selection dial to
<SUB-MENU>. Press .
2. Turn the selection dial to <AF-ASSIST POWER>, press . You would then be
able to turn on and select the power of the AF assist LED.
Note: The V6 II TX completely replicates the AF signal commanded by the connected
camera. If the camera does not support AF assist signal via the hot shoe, the AF
assist LED would not be activated.