In <DIAL DIRECTION>, the selection dial of the V6 can be configured to operate in a
<CLOCKWISE> or <ANTI-CLOCKWISE> direction. To increase the power level in the
main screen, for example, you would have to turn the selection dial to the left in the
clockwise setting, or turn it to the right in the anti(counter)-clockwise setting.
17.2 Selection Dial Lock
To prevent unintended turning of the selection dial and its consequence of affecting
the power levels, the dial can be locked in the main screen of the TX mode:
1. To lock the selection dial, press and hold the selection dial or for 2 seconds.
The LCD will show [lock] at the left upper corner.
2. To temporarily unlock the selection dial, press the selection dial or once.
Alternatively, press and hold any group button to select a group for power level
adjustment. The LCD will show [unlock] to indicate the temporary unlock status.
The dial will be locked again when no button or dial is pressed or turned in 2
seconds.
3. The temporary unlock mechanism can be enabled or disabled in the
<TEMPORARY UNLOCK> sub-menu.
4. To permanently unlock the selection dial, press and hold the selection dial or
for 2 seconds.
Note: The short-cut for adjusting the power level of a single group by pressing a
group button and turning the dial simultaneously (see Section 12.1.1) will be
unaffected.
17.3 Swap Control
In the main screen of the V6 II TX, pressing or the push-in selection dial once will
change it to one of the following modes:
y
Quick Power Adjustment Mode <QUICK POWER ADJ>: expanding the power
adjustment to 1EV step (see Section 12.1.3).
y
Zoom (Cactus) Mode <ZOOM (CACTUS)>: controlling the zoom level of the
Cactus RF60 (see Section 16.1.1).
This can be conf igured in <SWAP CONTROL>.
17.4 LCD Options
The LCD screen of the V6 II can be configured in the following ways:
