Installing the Cable Management Bar
6C110 Overview and Setup Guide
3-3
3.3
INSTALLING THE CABLE MANAGEMENT BAR
To install the cable management bar, proceed as follows:
1.
Remove the cable management bar from the shipping box. Ensure that
there are four screws inside the bag with the cable management bar.
2.
Refer to
Figure 3-1
. Line up the two holes on each side of the cable
management bar with the two holes located underneath the 6C110,
near the front of the chassis.
3.
Using a Phillips screwdriver, securely fasten the 4 screws.
Figure 3-1
Installing the Cable Management Bar
Bottom of Chassis
Front Panel of Chassis
Screws (4)
2016_05
Cable Management Bar
Summary of Contents for SmartSwitch 6500
