Powering Up a 6C110 with DC Power Supplies
6C110 Overview and Setup Guide
3-21
Installation Requirement
Each dc power supply input requires either a 48 Vdc or 60 Vdc power
source supplied by three 10 AWG (American Wire Gauge) copper wires.
These wires must be terminated with either ring or spade terminals that
accept a #6 screw.
3.13.1
Connecting a 6C205-2 or 6C210-2 to a 48/60 Vdc
Power Source
To connect the 6C205-2 or 6C210-2 to a 48/60 Vdc power source, face the
front of the power supply, then refer to
Figure 3-14
and proceed as
follows:
Figure 3-14
48/60 Vdc Power Supply Connections
1.
Connect the ground
terminal of the dc input power strip to an
appropriate earth ground.
2.
Refer to
Figure 3-14
for the proper connections to a 48/60 Vdc power
source. Then connect the output leads of the 48/60 Vdc power source
being used to the negative (-) and positive (+) terminals on the dc input
power strip.
3.
Repeat steps 1 and 2, if applicable, to connect a 48/60 Vdc power
source to a second dc power supply installed in the chassis.
4.
Restore power to the 48/60 Vdc power sources.
To prevent injury or damage to the equipment, remove power
from a 48/60 Vdc power source before proceeding with the
following steps.
DC Input Power Strip
+
-
Earth
Ground
ON/OFF
48 or 60 Vdc
Power Source
2016_98
Summary of Contents for SmartSwitch 6500
