Cabletron Systems SmartSwitch 6500, Overview And Setup Manual

Page: 46 / 50

Chapter 3: 6C110 Setup
3-22 6C110 Overview and Setup Guide
5. Press the on/off power switch of each power switch to on.
If you experience any problems during the installation of the 6C110,
contact Cabletron Systems for assistance.
3.14 REMOVING AND REINSTALLING THE FAN TRAY
The 6C110 is equipped at the factory with a removable fan tray that
allows for easy periodic cleaning and/or replacement if a problem occurs
with fan operation. A flat blade screwdriver is needed to remove and
reinstall the fan tray. To remove and reinstall the fan tray in the 6C110,
refer to
Section 3.14.1 and Section 3.14.2 .
3.14.1 Removing the Fan Tray
To remove the fan tray, refer to Figure 3-15 and proceed as follows:
1. Locate the ESD wrist strap shipped with the 6C110. Attach the ESD
wrist strap to your wrist and plug the cable from the ESD wrist strap
into the ESD grounding receptacle at the upper right corner of the
6C110.
2. Use a flat blade screwdriver to loosen the slotted screws located on
either side of the fan tray.
3. Slowly slide the fan tray out of its slot in the bottom of the chassis.
NOTE
The 6C205-2 and 6C210-2 sound an audible alarm if there is a
polarity reversal. If the alarm sounds, turn off the 48/60 Vdc
power source to that power supply. Then reverse the positive
and negative leads to the dc input power strip of that power
supply. Restore power from the 48/60 Vdc power source. If the
alarm sounds again, press the power switch to off and call
Cabletron Systems. Refer to
Section 1.5 .
!
CAUTION
The fan tray is hot swappable; however, the chassis must not
be run without the fan tray for extended periods of time, as it
will quickly overheat.