Chapter 3: DLM6C-AA Setup
3-16
DLM6C-AA Overview and Setup Guide
3.
Line up the rails on each side of the fan tray with the slot guides on the
chassis.
4.
Slide the fan tray forward until the faceplate of the tray is flush with
the face of the DLM6C-AA. If there is any strong resistance, remove
the fan tray and reinsert it.
5.
Once the tray is in place, tighten the slotted screws with a screwdriver
to secure the tray to the DLM6C-AA.
6.
When the DLM6C-AA is ready to be powered on, observe the LED on
the front of the fan tray. This LED should be red for a moment after
the power switch is turned on, and then change to green to indicate that
all fans are operating properly. If this LED remains red, it indicates
that one or more of the fans are not operating at the proper speed.
Check the fan tray to ensure that nothing is interfering with the
movement of the fans; also, check to make sure nothing is blocking the
air vents on the chassis or the fan tray. If the problem cannot be
located, contact your DIGITAL representative for assistance.
!
In the following step ensure that you do not force the fan tray
into place, as it may damage the unit.
!
The fan tray is hot swappable; however, the chassis must not
be run without the fan tray for extended periods of time, as it
will quickly overheat.
