DLM6C-AA Overview and Setup Guide
3-1
CHAPTER 3
DLM6C-AA SETUP
This chapter contains instructions on setting up the DIGITAL
DLM6C-AA chassis. A Phillips screwdriver is needed to install the unit
in a 19-inch equipment rack, to install the cable management bar, to
secure the power supply module, and to remove and reinstall the fan tray.
Refer to
Chapter 2
for the guidelines that must be followed to install the
DLM6C-AA.
3.1
UNPACKING THE DLM6C-AA
To unpack the DLM6C-AA, proceed as follows:
1.
Unpack the DLM6C-AA by carefully removing it from the shipping
box. (Save the shipping box and materials in the event the chassis has
to be reshipped.)
2.
Remove the chassis from the protective plastic bag. (Save the bag in
the event the unit must be reshipped.)
3.
Examine the DLM6C-AA carefully, checking for damage. If any
damage is noted, DO NOT install the chassis. Contact your DIGITAL
representative immediately.
4.
Remove the accessory package.
5.
Remove the ESD wrist strap package.
Only qualified personnel should install or service this unit.
Unpack DLM6C-AA components only as needed. Leave the
components in their respective shipping cartons until you are
ready to install that component.
!
Observe all Electrostatic Discharge (ESD) precautions when
handling sensitive electronic equipment.
