Setting Up the DLM6C-AA
DLM6C-AA Overview and Setup Guide
3-7
4.
Slide the power supply module into the slot labeled PS1 as follows:
a.
Hold the module by placing one hand on the handle located on the
module front panel and using the other hand to support the body
of the module.
b.
With the LED at the top of the power supply module, align the
circuit card of the power supply module with the slotted paths on
the top and bottom of the opening.
c.
With the power supply inserted into the slotted paths, carefully
slide the module forward until it is connected to the backplane
with the front panel flush with the face of the DLM6C-AA. Do not
force the module into place. If significant resistance is
encountered before the front panel is flush, remove and reinsert
the power supply.
d.
Secure the power supply to the chassis by using a screwdriver to
tighten the two slotted screws on the top and bottom of the power
supply. For proper chassis grounding, the screws must be properly
tightened.
5.
If you are installing a second power supply, remove the blank plate
from the second power supply slot (keep the blank plate in the event
you need to remove the power supply), and repeat steps 1– 4.
!
Forcing a misaligned module into place can damage the
module and/or the chassis backplane.
