Powering Up a DLM6C-AA with an AC Power Supply
DLM6C-AA Overview and Setup Guide
3-11
3.3
POWERING UP A DLM6C-AA WITH AN AC POWER
SUPPLY
To power up a DLM6C-AA with the HA205-AA ac power supply
module, proceed as follows:
1.
Plug one end of the power cord (supplied with the power supply) into
the ac power socket on the bottom of the power supply.
2.
Plug the other end of the power cord into an ac receptacle. Turn on the
power supply using the switch located above the power socket.
3.
Ensure that the power LED is green.
4.
Ensure that all fans in the fan tray unit are operating properly when
power is received from the power supply modules (fan tray LED will
be green).
If you experience any problems during the installation of the
DLM6C-AA, contact your DIGITAL representative for assistance.
3.4
POWERING UP A DLM6C-AA WITH A DC POWER
SUPPLY
This section provides information on how to connect the HA205-MD dc
power supply to 48 or 60 Vdc (48/60 Vdc) power sources. The
HA205-MD is installed and functions the same as the ac power supply for
the DLM6C-AA. The dc power supply has an on/off switch and an input
power strip, and is rated at 510 watts. The on/off power switches and
input power strips are similar to the ones shown in
Figure 3-6
.
If two power supplies are installed, repeat the following
procedure for each supply.
The on/off switch on the HA205-MD power supply contains a
30 Amp circuit breaker.
