Small Office Remote Access Switch 155
C
ONFIGURING
D
EVICE
L
EVEL
D
ATABASES
On-node Device Entries
IP Routing with PPP Bridge Devices (Using BCP)
To allow devices to connect to the CyberSWITCH using IP routing through a PPP Bridge device,
you must configure a RLAN IP Network Interface. IP routing must also be enabled. For each PPP
Bridge using this type of connection, you may need to enter the Device Name, a Calling Line Id, a
PAP Password or a CHAP Secret, and an IP (Sub) Network Number.
The following table identifies the configuration requirements for possible security options for IP
Routing with PPP Bridge Devices.
Note:
If CHAP Security is enabled, and Outbound Authentication has not been disabled, a CHAP
Secret must be entered for both the remote device and for the CyberSWITCH. Refer to
System Information
regarding the System Secret. If Outbound Authentication has been
disabled, a CHAP Secret is not required for the remote device.
Security Mode Configuration
On-node Device Table Configuration Data
Calling Line Id
PAP or CHAP
Security
Calling Line Id
PAP Password
or
CHAP Secret
IP (Sub)
Network
Number
Disabled
Enabled
Not Requested
Required
Required if
only IP
Routing is
Enabled
Enabled
Enabled
Optional per
device entry
Required
Required if
only IP
Routing is
Enabled
Enabled
Disabled
Required
Optional
Required if
only IP
Routing is
Enabled
