Activating Configuration Changes and Saving the Configuration File
Software Installation and Setup
3-17
Here is an example:
4.
Enter the system show version command to verify that the new boot PROM software is on the
internal memory of the 6SSRM-02.
Activating Configuration Changes and Saving the
Configuration File
The 6SSRM-02 uses three special configuration files:
•
Active – The commands from the Startup configuration file and any configuration commands
that you have made active from the scratchpad (see below).
Caution
: The active configuration remains in effect only during the current power cycle. If you
power down or reboot the 6SSRM-02 without saving the active configuration changes to the
Startup configuration file, the changes are lost.
•
Startup – The configuration file that the 6SSRM-02 uses to configure itself when the system
is powered on.
•
Scratchpad – The configuration commands you have entered during a management session.
These commands do not become active until you explicitly activate them. Because some
commands depend on other commands for successful execution, the 6SSRM-02 scratchpad
simplifies system configuration by allowing you to enter configuration commands in any order,
even when dependencies exist. When you activate the commands in the scratchpad, the
6SSRM-02 sorts out the dependencies and executes the command in the proper sequence.
ctron-ssr-1# system promimage upgrade 10.50.11.12 prom2
Downloading image ’prom-1.1.0.0’ from host ’10.50.11.12’
to local image prom-1.1.0.0 (takes about 3 minutes)
kernel: 100%
Image checksum validated.
Image added.
Summary of Contents for 6SSRM-02
Page 2: ......
Page 12: ...x ...
Page 40: ...Getting Help 1 26 Introduction ...
Page 46: ...Completing the Installation 2 6 Installation ...
