Setting Basic System Information
3-6
Software Installation and Setup
If you exit Configure mode (by entering the exit command or pressing Ctrl+Z) before
activating any of your changes in the scratchpad, the CLI will ask you whether you want to
make the changes in the scratchpad active by displaying the following message:
8.
Enter yes or y to activate the changes.
9.
To display the active configuration, enter the system show active-config command, as shown
in the following example:
Changes in the active configuration take effect on the running system but will not be restored
following a reboot.
10.
To ensure that changes are restored following a reboot, you must save the active database to the
Startup configuration file by taking the following steps:
a.
Enter the exit command to return to Enable mode.
b. Enter the copy active to startup command.
The CLI displays the following message:
11.
Enter yes or y to add the active configuration to the Startup configuration file.
Note:
You also can save active changes to the Startup configuration file from within Configure
mode by entering the save startup command.
See
“Activating Configuration Changes and Saving the Configuration File” on page 3-17
for more
information about the scratchpad, active database, and Startup configuration.
Do you want to make the changes Active [yes]?
ctron-ssr-1# system show active-config
Running system configuration:
!
! Last modified from Console on Mon Jan 19 11:55:35 1998
!
1 : system set name "ctron-ssr-1"
2 : system set location "Sunnyvale, CA"
3 : system set contact "John Smith"
Are you sure you want to overwrite the Startup configuration [no]?
Summary of Contents for 6SSRM-02
Page 2: ......
Page 12: ...x ...
Page 40: ...Getting Help 1 26 Introduction ...
Page 46: ...Completing the Installation 2 6 Installation ...
