Connecting to the Network
6E122-26, 6E132-25, 6E123-26 and 6E133-25 User’s Guide
3-13
Figure 3-7
FE-100FX and FE-100F3 Port
4.
Verify that a link exists by checking that the port RX LED is on
(flashing amber, blinking green, or solid green). If the RX LED is off
and the TX LED is not blinking amber, perform the following steps
until it is on:
a.
Check that the power is turned on for the device at the other end of
the link.
b.
Verify proper crossing over of fiber strands between the
applicable port on the 6E12X-26 and the fiber optic device at the
other end of the fiber optic link segment.
NOTE
The port RX LED flashes green and amber during bootup.
25
26
FE-100FX
RX LED
TX LED
Summary of Contents for 6E122-26
