General Configuration Screen
6E122-26, 6E132-25, 6E123-26 and 6E133-25 User’s Guide
5-53
5.15.11 Configuring the COM Port
The 6E12X-26 and 6E13X-25 COM ports support the following
applications:
•
Local Management connections
•
American Power Conversion Uninterruptible Power Supply (UPS)
connections
To configure the COM port, proceed as follows:
1.
Use the arrow keys to highlight the Com field.
2.
Press the SPACE bar to choose either ENABLED or DISABLED.
The COM port must be ENABLED if it will be used for Local
Management or UPS applications. Select DISABLED if you wish to
disable the COM port for additional module security.
!
CAUTION
Before altering the COM port settings, ensure that a valid IP
address is set for the module or chassis. (Refer to
Section 5.15.1
,
Setting the IP Address
.) Read this entire
COM port configuration section before changing the settings of
the COM port.
NOTE
Refer to the Release Notes included with the 6E12X-26 and
6E13X-25 to verify which COM Port applications are currently
supported.
!
CAUTION
Do NOT disable or alter the settings of the COM port while
operating the current Local Management connection through a
terminal. Altering the COM port settings disconnects the Local
Management terminal from the port, and ends the Local
Management session.
!
CAUTION
If the COM port is reconfigured without a valid IP address set
on the module or chassis, the message shown in
Figure 5-20
displays. Do not continue unless the outcome of the action is
fully understood.
Summary of Contents for 6E122-26
