46
46
12
I/O Interface
For use in a network the printer is equipped with an I/O interface.
12.1 Pin Assignment
The interface has a 25 pin SUB-D connector.
Pin 25
Pin 14
Pin 13
Pin 1
Figure 25 I/O interface
i
Note!
The function of the outputs on the pins 4, 9 10 and 21 can be re-defined temporarily by direct programming
e.g. to control external devices with the user bits 0 to 3
Programming Manual.
Pin
Signal Name
Description
Activation / Active State
1
-
-
Do not use
2
-
-
Do not use
3
-
-
Do not use
4
FEEDON
Media transport ON
Labels are fed by the printer
+24 V on Pin 4
Bit 0
User Bit 0 is set
5
-
-
Do not use
6
GND_INT
Ground (0 V)
for sensors or trigger switches
7
-
-
Do not use
8
-
-
Do not use
9
JOBRDY
Print job ready
Print jobs are stored in the print module.
+24 V on Pin 9
Bit 1
User Bit 1 is set
10
READY
Printer is ready
+24 V on Pin 10
Bit 2
User Bit 2 is set
11
-
-
Do not use
12
REPRINT
The last printed label will be repeated.
+24 V between Pin 12 and Pin 25
13
START
Print start signal
only for
Print on demand = On
+24 V between Pin 13 and Pin 25
14
PAUSE
Pause ON/OFF
Pause ON when +24 V between
Pin 14 and Pin 25
15
RIBWARN
Warning end of ribbon
The ribbon supply roll diameter has undershot a predefined
level
0 V on Pin 15
16
LBLREM
Label removed
For peel-off mode only.
Confirmation of the superior control that the label has been
taken from the peel-off position.
Required for the validity of a new start signal.
Switch on +24 V between
Pin 16 and Pin 25
17
JOBDEL
Cancel print job
The current print job is canceled and deleted from the print
buffer.
Switch on +24 V between
Pin 17 and Pin 25
18
RSTERR
Reset
Error state of the printer will be reset.
Switch on +24 V between
Pin 18 and Pin 25
19
P24_INT
Internal operating v24 V, Si T 100mA
for external consumers e.g. sensors, trigger switches
20
P24_EXT
External operating v24 V
