16
16
6
Configuration
6.1.4
Tearing-off
Start menu.
Select
Setup > Tearing-off.
Parameter
Meaning
Default
Tear-off mode
Positioning the label medium for tearing off at the tear-off plate.
On
: Additional advancement of the label medium which positions the
label gap after the last printed label at the dispense plate.
Off
: Label advance stops once the last label has fully passed the print
line.
Ein
Tear-off position
Shifting of the tear-off position in the direction of paper flow. With
positive values, the label strip is transported farther out of the printer.
0.0 mm
Table 8
Parameters of the
Setup > Tearing-off
menu
6.1.5
Cutting
If cutter is not installed, access only with service key inserted.
Start menu.
Select
Setup > Cutting.
Parameter
Meaning
Default
Cut position
Offset of the cut position relative to the rear label edge.
The setting can also be adjusted by the software.
The settings of configuration
and software are added together.
0.0 mm
Perforation level
with perforation cutter only
Setting of the perforation depth.
The setting can also be adjusted by the software.
The settings of configuration
and software are added together.
0
Table 9
Parameters of the
Setup > Cutting
menu
6.1.6
Peeling-off
If peel-off module is not installed, access only with service key inserted.
Start menu.
Select
Setup > Peeling-off.
Parameter
Meaning
Default
Peel-off position
Shift the position of the dispensed label relative to the dispensing edge.
The setting can also be adjusted by the software.
The settings of configuration
and software are added together.
0.0 mm
Backfeed delay
Delay time between removing the label from the peel position and the
backfeed of the label.
250 ms
Backfeed position
Offset of the backfeed movement
1.0 mm
Table 10
Parameters of the
Setup > Peeling-off
menu
