Position the port of the pulley so that it is opposite the
flat bar at the end of the stainless steel shaft. Push the
plate towards the axle to drive the stainless steel shaft
into the pulley.
7
Thread the HSHC M6x30 screw (B) through the
aperture in the pulley port, tighten in the stainless steel
shaft tapping and lock it.
8
B
Remove the HSHC M6x20 (B) screw from the end of the
axle on the reduction gear housing side.
3
Remove the protective cover from the gears by inserting
both index fingers into the holes and pulling. Dispose of
the cover (only used during transport). Keep the reduction
gear housing tilted upwards to avoid dropping the gears.
4
B
Loosen the two HSHC M8x30 (A) screws on the pulley
on the motor side.
6
A
An exploded view of the reduction gear assembly.
5
Protective
cover
3 black
gears
4 black
gears
3 pignons
noirs
4.
ASSEMBLY PRIOR TO SUBMERSION
In addition, to clamp the assembly together, insert the
two HSHC M8x30 screws (A).
9
A
A
B
At the opposite end to the motor, secure the bearing to the
end fixing plate using the 4 CSFSH M8x50 screws and
the hex collar nuts. Caution! the curve on the top side of
the end fixing plate should be directed towards the axle.
10
2019/01 - Indice de révision : N - Code : 34201
PROTECTION & SÉCURITÉ
36/60
