Buyers 16014004, Installation Manual

Page: 3 / 16

3 3042233_B
10
1
2
4
3
5
6
7
8
LIFT POINTS
4.0
3.5
MDII Moldboard/Lift Frame Assembly
ITEM QTY. PART NO. DESCRIPTION
1 1 16015004 MDII Lift Frame Assembly
2 1 16111638 Light Bar
3 1
16160700A Halogen Light Kit (Sold Separately)
16160800 LED Light Kit (Sold Separately)
4 1 16111520 Light Bar Fastener Kit
5 1 16122100 Blade Guide Kit (Set of 2)
6 1 16101110A Trip Pin Kit (Set of 2)
7 1 16101220 Trip Spring Mount Kit (Set of 2)
8 2 16101200 Trip Spring
9
1 16020412 MD68II Moldboard w/Deflector
1 16020422 MD75II Moldboard w/Deflector
1 16020432 MD80II Moldboard w/Deflector
Bill of Materials
The moldboard can be propped on a 4x4 or the edge
of a shipping pallet to get into position for mounting
onto the a-frame. The moldboard should be lifted
and held in place until secured with a crane using the
points shown. The lift frame can be slid forward on
the shipping pallet and raised using a pallet jack to
easily mate with the moldboard (Fig. 2).
Fig. 2
Fig. 1
1. Attach the Moldboard to the Sector using the Trip
Pin Kit (6) on both the Driver and Passenger Sides.
Do NOT detach the crane as the moldboard is still not
secured.
2. Install the Trip Springs (8) and Trip Spring Hardware
(7) as shown. Tension the trip springs until there is
approximately a .030” gap. It is important that all
springs be at the same level of tension.
3. Install the snow deflector by loosening the fasten-
ers on the top strip of the moldboard. The deflector
fits between the black retainer strip and the stainless
moldboard. Only the OUTER TWO fasteners need to
be completely removed.
4. Install the blade guides (5) as shown.
5. The shoes as installed have been adjusted for ship-
ping and may need to be repositioned after the plow
is mounted to a vehicle.