![background image](http://html1.mh-extra.com/html/buyers/16014004/16014004_installation-manual_2836052010.webp)
10
3042233_B
Switched Ground
"A" SHORT LEAD
TO HEADLIGHT ADAPTER
"B" LONG LEAD
TO HEADLIGHT ADAPTER
ORANGE WIRE
TO GRILL HARNESS
BLACK WIRE
TO GROUND
TURN SIGNAL
CONNECTORS
16160104
LIGHT/GRILL HARNESS
16160102
RELAY HARNESS
WHITE/BLACK
TO ORANGE
WHITE/BLACK TO
CONTROL HARNESS
• Cut open the loom on the GRILL HARNESS near the 8-pin connector to locate the WHITE/BLACK wire.
This wire has male and female connectors in line.
• Disconnect the WHITE/BLACK wires (male and female connectors) from each other on the GRILL HARNESS.
• Connect the ORANGE wire on the RELAY MODULE to the WHITE/BLACK wire on the GRILL HARNESS.
This supplies ground to the relay coils when the plow is connected.
• Connect the WHITE/BLACK wire on the GRILL HARNESS to the RED/WHITE wire on the CONTROL
HARNESS. This supplies ignition switched power to the common wire of the plow lights.
8.
With the plow disconnected, check all light functions on the vehicle.
9.
Connect the plow and check all light functions on the plow.
Optional Accessory Wires
There are two extra blunt cut wires (RED and BLUE) in the GRILL HARNESS near the 8-pin connector. These
wires are for optional accessories mounted on the plow. They end at the 5-pin light connectors on the plow and
go to both the driver and passenger side light connectors. If these are used, they should be properly terminated.
These wires are suitable for 15A of current.
Summary of Contents for 16014004
Page 15: ...15 3042233_B...