7
3042233_B
Vehicle Side Electrical Installation
The SnowDogg
®
plow has separate harnesses for Hydraulic and Lighting for ease of installation and trouble-
shooting. Either harness can be omitted without affecting the functionality of the other system.
Control Harness Installation
The truck side control harness is routed through the grill, by the battery, and through the firewall to the control-
ler. It is preferable when possible to keep the plow connector on the driver side to make mount/dismount easier
and faster.
It is important that the 15A fused power lead go to an ignition switched source. Hooking direct to an “always on”
source will cause a constant current draw and drain the vehicle battery. If an ignition switched source cannot be
found, any switch rated at 15A can be used to turn off the power.
CAUTION
Keep all connectors greased with dielectric grease on a regular basis to minimize corrosion & potential damage
or wear to the pins. It is critical that all electrical connections be tight and secure. Loose connections on the plow
circuit can cause overheating, component failure, or intermittent opration.
POSITIVE (+)
TERMINAL
NEGATIVE (-)
TERMINAL
TO ACC POWER (+12V/15A)
IGNITION SWITCHED
BLACK
RED/WHITE
BLACK
RED
RED 4GA
BLACK 4GA
TO CHASSIS OR
BATTERY GROUND
TO CONTROLLER
THROUGH GRILL
SEE INSTRUCTIONS
15A FUSE
TRUCK FIREWALL
DRILL Ø 7/8" HOLE AND
PROTECT WITH GROMMET
16160302 CONTROL HARNESS
Summary of Contents for 16014004
Page 15: ...15 3042233_B...
