4
3042233_B
Bill of Materials
ITEM
QTY.
PART NO.
DESCRIPTION
1
1
16014004
VMDII Lift Frame Assembly
2
1
16111638
Light Bar
3
1
16160700A
Halogen Light Kit (Sold Separately)
16160800
LED Light Kit (Sold Separately)
4
1
16111520
Light Bar Fastener Kit
5
1
16122100
Blade Guide Kit (Set of 2)
6
2
16102142
Clevis Pin Kit
7
1
16101170
Hinge Pin Kit
8
1
16113262
Center Deflector Cap
9
1
16020712
VMD75II Moldboard w/Deflectors
Fig. 3
VMDII Moldboard/Lift Frame Assembly
Fig. 4
1.
Assemble the V-plow MOLDBOARD WINGS (9a
and 9b) to the LIFT FRAME (1) as shown in Fig 3 using
the HINGE PIN KIT (7). This can be done easiest by
sliding the lift frame forward on its shipping pallet as
shown in Fig. 4. Tap the hinge pin (7) down
adjusting the wing positions as you go to allow for
complete assembly.
9a
9b
1
2
3
4
5
6
7
8
7
LIFT FRAME
SHIPPING PALLET
4.75
4.00
2.
Attach both angle cylinders on the LIFT FRAME to
the MOLDBOARD as shown using the 7/8” clevis pins
and hardware (6). The wings should move freely to
allow attachment to the cylinder rods.
3.
Install the DEFLECTOR CAP (8) with hardware as
shown
4.
The trip spring mechanisms have been pre-
installed and tensioned. They may need to be
straightened as they may have shifted during shipping
and handling.
5.
Install the snow deflectors by loosening the fas-
teners on the top strip of each wing moldboard. The
deflector fits between the black retainer strip and the
stainless moldboard. Only the OUTER TWO fasteners
need to be completely removed.
6.
Install the blade guides (5) as shown.
7.
Grease the 7 hinge pin tubes using a needle style
grease gun tip. Do NOT install grease fittings in
these holes as they will be damaged by normal plow
movement.
Summary of Contents for 16014004
Page 15: ...15 3042233_B...