Bush DLED49287HDCNTDFVP, Instruction Manual

Page: 12 / 55

Antenna Connection
Connect the aerial plug to the AERIAL INPUT (ANT) socket
located on the back of the TV.
Inserting the Batteries into the Remote
Remove the back cover to reveal the battery compartment.
Insert two size
AAA batteries. Make sure the (+) and (-)
signs match (observe correct polarity). Do not mix old
and new batteries. Replace only with same or equivalent
type. Place the cover back on.
Connect Power
IMPORTANT: The TV set is designed to operate on 220-
240V AC, 50 Hz socket. After unpacking, allow the TV
set to reach the ambient room temperature before you
connect the set to the mains. Plug the power cable to
the mains socket outlet.
Switching On/Off
To Switch the TV On
Connect the power cord to a power source such as a
wall socket (220-240V AC, 50 Hz).
To switch on the TV from standby mode either:
• Press the Standby button, Pro/- or a numeric
button on the remote control.
• Press the side function switch on the TV until the TV
comes on from standby.
To Switch the TV Off
Press the Standby button on the remote control or press
the side function switch on the TV until the TV switches
into standby mode.
To power down the TV completely, unplug the power
cord from the mains socket.
Note:
When the TV is switched into standby mode, the
standby LED can blink to indicate that features such as
Standby Search, Over Air Download or Timer is active.
The LED can also blink when you switch on the TV from
standby mode.
Getting to know your TV
You’ll be up and running in no time
Getting to know your TV
11
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 604 0105 .