Burstner A 650, Instruction Manual

Page: 142 / 262

142
A-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN
Appliances
9
Switching on:
„
Push the sliding regulator (Fig. 151,1) of the flow control downward to the
desired position. The water circulation is open.
„
Turn the fan switch (Fig. 151,2) for the circulation fan in a clockwise direc-
tion.
Switching off:
„
Turn the fan switch (Fig. 151,2) to " ".
„
Push the sliding regulator (Fig. 151,1) of the flow control upward as far as
it goes.
9.2.6 Electrical floor warming unit (special equipment)
The transformer (Fig. 152,1) for the electrical floor warming unit is installed
either in the bench seat or in the bedding box, depending on the model.
Fig. 151 Operating controls for auxiliary
heat exchanger
X
On models with electrical floor warming unit, never drill holes in the floor
or screw in any screws. Careful with sharp objects. There is danger of a
power cut or a short circuit due to damage to a heater wire.
Z
Do not cover the transformer. Danger of overheating!
Z
The electrical floor warming unit only operates if the vehicle is connected
to the 230 V power supply.
Z
The output of the electrical floor warming unit alone is not sufficient to heat
the living area.
Fig. 152 Transformer for electrical floor
warming unit
Fig. 153 Switch for electrical floor
warming unit