Burstner A 650, Instruction Manual

Page: 137 / 262

137
A-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN
Appliances
9
9.2.4 Alde hot-water heater (only Argos 747-2)
The hot-water heater is installed at the bottom of the wardrobe or under the
beds.
Operating unit The operating unit is divided into two sections:
z
Display (touch screen)
z
Control buttons
Control buttons The control buttons have the following functions:
Display The display (Fig. 144,1) is designed as a touch screen. Touching the symbols
calls up the relevant function.
Start screen The Start screen appears on the display after the heater is switched on. The
Start screen contains the following information:
Z
Never run hot-water heater without heating fluid. Observe notes in
chapter 12.
Z
Never drill holes in the floor. This might damage the hot-water pipes.
Z
The circulating pump must always be turned on when the hot-water heater
is in operation.
Z
We recommend to bleed the heating system after the initial heater opera-
tion and to check the glycol content. Observe notes in chapter 12.
Z
When the heater is turned on, it starts with the last settings used.
Z
For further information, see the separate manufacturer's instruction manual
and observe the maintenance instructions found in chapter 12.
Z
For further information about the use of the boiler see section "Boiler".
Fig. 144 Operating unit for hot-water
heater
1 Display (touch screen)
2 "Menu" button
3 On/Off button
Z
When no button is pressed, the operating unit automatically switches to
home position after two minutes.
Z
Changes to the settings are saved automatically after 10 seconds.
Pos. in
Fig. 144 Button Function
2 MENU Open adjustment menu
3
Activate heating