Burstner A 650, Instruction Manual

Page: 106 / 262

106
A-Modell - 11/12 - Ausgabe 09/11 - 2096161 - BUE-0036-10EN
Electrical system
8
Measures:
„
Switch off all electrical appliances that are not absolutely essential at the
corresponding switch.
„
If necessary, use the 12 V main switch to switch the 12 V power supply
back on for a short while. This is only possible, however, when the battery
voltage is above 11 V. If the voltage is below this level, the 12 V power
supply cannot be switched on again until the living area battery has been
recharged.
Charging the battery When the vehicle engine is running, a relay in the transformer/rectifier alter-
nator switches on the living area battery and the starter battery together and
recharges them with the vehicle generator. When the vehicle engine is
switched off, the batteries are automatically disconnected from one another
again by the transformer/rectifier. This prevents the starter battery from being
run down by electrical appliances in the living area. The starting capability of
the vehicle is thus preserved. The terminal voltage of the living area battery or
the starter battery can be read on the panel.
If the vehicle is connected to the 230 V power supply, the living area battery
and the starter battery are automatically charged by the charger module on the
transformer/rectifier. The starter battery is only charged with a float charge.
The charging current is adapted to suit the charging condition of the battery.
This ensures that it is not possible to overload the battery.
To make use of the maximum output from the charger module on the trans-
former/rectifier, switch off all electrical appliances during charging.
8.5 Panel IT 96-2
8.5.1 12 V main switch
The 12 V main switch (Fig. 117,7 and 9) switches the panel and the 12 V
power supply to the living area on and off.
Exception: Depending on the model, heater, basic light (lighting in the
entrance area), entrance step, spare 4 and a refrigerator with automatic power
selection system (AES) remain ready to operate.
Switching on:
„
Press switch (Fig. 117,9) "12 V": The 12 V living area power supply is
switched on. The indicator lamp (Fig. 117,8) lights up green.
Switching off:
„
Press switch (Fig. 117,7) " O ": The 12 V living area power supply is
switched off. The indicator lamp (Fig. 117,8) goes out.
Fig. 117 Panel IT 96-2
1 "ALARM" warning light for the living
area battery
2 V/tank gauge
3 230 V indicator lamp
4 Rocker switch for water pump On/
Off
5 Switch for reading the filling level in
the water tank
6 Switch for reading the filling level in
the waste water tank
7 12 V main switch OFF
8 12 V indicator lamp
9 12 V main switch ON
10 Switch for reading the battery
voltage of the living area battery
11 Switch for reading the battery
voltage of the starter battery