Burster TRANS CAL 7280, Operating Instruction, Page: 17 / 40

Model 7280 TRANS CAL
Page 17
4. Manual Operation
4.1 Menu description
1 MEASURE Measuring mode
SENSOR__ Sensor selection for measuring mode, sensor 0 - 9
Selection of the sensor parameter set of the measurement. The
sensor parameter set must comply with the connected sensor.
2 SYSTEM All system parameters are stored in this menu column.
2.1 LANG Language adjustment
The menu language is available in English, German, French and
Spanish.
2.2 INFO Information query was factory-configured and is not modifiable.
SW no. Firmware version
2.3 SCI Interface configuration
BAUD Baud rate adjustment; it must comply with the receiver (PC or printer).
SCI MODE The interface configuration only refers to the measuring mode, not
the log mode!
SCI off Interface switched off
HAND When pressing ENTER in the measuring mode, a measured value
is displayed.
AUTO
1
Interval time, adjustable from 10 ms to 1 h (at high measuring rate
only possible with the highest baud rate).
TRIGGER At rising edge on the trigger input, in measuring mode a measured
value is displayed.
INTERFAC Interface selection
USB USB interface is activated
RS232 RS232 interface is activated
2.4 RATE Measuring rate
1
and average value
RATE Measuring rate adjustment, selectable from 1/s to 1000/s. For fast
procedures (screw joint, insert press...) always select a fast measur-
ing rate, e.g. 1000/s, for very slow procedures select a small rate,
e.g. 1/s.
AVERAGE Average determination, the numbers indicate the average determina-
tion by the amount of measurements. Applicable for e.g. vibrations,
control oscillations...
2.5 PASS Password query
RATE Entering password 9373 allows to change to menu 3 ADJUST . Here,
the sensor parameters can be changed.
2.6 LCD LCD contrast adjustment
If the LCD becomes unreadable by external influences, e.g. solar
radiation, heat or cold, the LCD contrast can be changed by press -
ing key
▲
or
▼
.
1
If the SCI
→
AUTO interval time is shorter than the adjusted measuring rate, the same measured value
will be issued on the interface until a new value is entered.