Burster 9180, Manual

Page: 88 / 109

Model 9180
burster
Digital Panelmeter
Page
M
A
X
M
I
N
1
HOLD
TARA
2
TARE RESET
ESC
LIMIT MAX/MIN DATA
ENTER
3
4
M
A
X
M
I
N
1
HOLD
TARA
2
TARE RESET
ESC
LIMIT
MAX/MIN
DATA
ENTER
3
4
4-44
4.4.12 Transfer configuration
Fig. 4.4.12a
In the input level to module 50 (Fig. 4.4.8)
you press the "
ENTER
" key to reach
programming mode and " " three times
to reach the level depicted in Fig. 4.4.12a)
(
54 -trAnS in the auxiliary display).
This allows you to copy a device setting
into a different device via the serial
interface.
Press "ENTER" to select this menu or
: To proceed to menü 54
ESC
: Returns you to the input level
-Pro-
.
Fig. 4.4.12b
A flashing number appears in the display
(0 or 1).
"
0
" means that the option is not activated
and "
1
" means that the option can be
used.
If the value displayed (0 or 1) corresponds
to the desired option press "
ENTER
" or
ESC
: To return to the input level
-Pro-
. If this is not the case press
: To change the number and then
"
ENTER
" to save the entry and
go to the the
-Pro-
level.
SEnd command (transfer configuration)
To be able to use this command, you must have previously selected the option "1" in menu
54 -trAnS- and the option "ISo" in menu 51 -SoFt- (for the ISO 1745 communications
protocol).
To copy the programming from one device to the other, the 9180 on the receiving side must have
the same address as the transmitting 9180 (see pages 4-32/33).
You are in
menu 54
and you have set the
trAns-Parameter
to "
1
". Confirm this by pressing
" ENTER ". You will now find yourself back in the " Pro " level.
Press the "
TARE
" key and
SEnd
appears in the secondary display.
If you now wish to transfer the program parameters, press "
ENTER
" or if you wish to cancel the
command, press "
ESC
". [1st level -Pro-, 2nd level - the "TARE" key, 3rd press "ENTER"].