Burster 9180, Manual

Page: 51 / 109

burster
Digital Panelmeter
Model 9180
Page
M
A
X
M
I
N
1
HOLD
TARA
2
TARE RESET
ESC
LIMIT MAX/MIN
DATA
ENTER
3
4
M
A
X
M
I
N
1
HOLD
TARA
2
TARE RESET
ESC
LIMIT
MAX/MIN
DATA
ENTER
3
4
M
A
X
M
I
N
1
HOLD
TARA
2
TARE RESET
ESC
LIMIT MAX/MIN
DATA
ENTER
3
4
4-7
4.1.6 Access for programming the analog output
Fig. 4.1.6
By pressing the
"ENTER"
key you go
from operation to programming mode (
Dis-
play -Pro-
).Then keep pressing the " "
key until you are in level 40.
Press "
ENTER
" to reach the first menu or
: To go to the next programming
mode
ESC
: To return to the input level of
programming mode (
-Pro-
).
Fig. 4.1.6.1a
Fig. 4.1.6.1b
With the " " key you can select the output
signal type ("
Udc
" for 0-10 V and "
Idc
" for
4 - 20 mA). If the desired output type
appears in the display, press "
ENTER
" to
confirm and return to programming mode
(Display
-Pro-
).
ESC
: Returns you to the -
Pro-
mode
without saving.
4.1.6.1 Selecting the output signal type
Starting from level 40 with the pressing of
"
ENTER
" there appears on the display the
input display of menu 41 (Fig. 4.1.6.1a),
-
Udc-
for 0 - 10 V or
-Idc-
for 4-20 mA). If
the desired output signal type appears,
press the "
" key to go into the menu for
the scaling of this signal type (Fig. 4.1.6.2a).
ENTER : If you would like to change the
output signal type, press
"
ENTER
" again. The two
hyphens disappear and the
device is ready for signal type
selection using the "
" key.
ESC
: Returns you to the input level of
programming mode (Display
-Pro-
).