Burster 9180, Manual

Page: 54 / 109

Model 9180
burster
Digital Panelmeter
Page
M
A
X
M
I
N
1
HOLD
TARA
2
TARE RESET
ESC
LIMIT MAX/MIN DATA
ENTER
3
4
M
A
X
M
I
N
1
HOLD
TARA
2
TARE RESET
ESC
LIMIT MAX/MIN DATA
ENTER
3
4
4-10
4.1.6.3 Filter
In level 40 depicted in Fig. 4.1.6 press
"
ENTER
" once to go to the menu selection
level and press " " twice to go to the input
level of menu 43
-FILT-
(Fig. 4.1.6.3a). In
this menu you can select whether the
speed of the analog output should respond
as a function of the display or the input
signal. To determine the parameter press
the "
ENTER
" key. You then go to the level
shown in Fig. 4.1.6.3b.
: Takes you to the selection menu
for the output type (Fig.4.1.6.1a).
ESC : Returns you to the input level of
the programming module (Dis-
play
-Pro-
).
Fig. 4.1.6.3a
Fig. 4.1.6.3b
If you would like to change the existing
configuration, press "
" so that the
message in the main display changes
["
-on-
" / "
-oFF-
"] and press "
ENTER
" to
confirm the entry and go to the
-Pro-
level.
In some applications the input signal
changes so rapidly that not only all the
changes, but also undesired input signal
peaks are reflected at the output.
In these cases you should prolong the
reaction time of the output by sending the
signal through a filter which has the same
variable as the filter for the display. In this
menu step there are two possibilities : For
"
OFF
" the output changes as a function of
the input (without filter) and for "
ON
" the
output reflects the display value by means
of the corresponding filter.