burmeier Vertica-Homecare, Instruction Manual

Page: 62 / 84

Instruction Manual for Vertica-Homecare Bed
Page 63
6.5.3 Replace Handset
 Unplug the mains cable.
 Remove the locking device on the control unit/ junction box MJB (use a
screwdriver).
 Pull the handset plug out of the control unit.
 Plug the new handset plug into the control unit (nut facing up).
Make sure that the O-ring on the plug is not damaged. This ring ensures that the
plug is tightly sealed.
 Re-attach the locking device.
 When routing the handset cable, ensure that it cannot be damaged by any
moving parts of the bed.
 Test the function of the power adjustments!
6.5.4 Replace Mains Cable
 For easy installation, move the mattress base to the highest position.
 Unplug the mains cable.
 At the head end of the chassis, release the strain relief of the mains cable.
 Remove the mains cable from the holders.
 Pull the IEC connector out of the control unit. To do this, use a screwdriver to
press the red security hooks together slightly on the IEC connector.
 Plug the new IEC connector into the control unit!
The red securing clips must prevent the plug from being disconnected
unintentionally from the control unit!
 Place the mains cable back into the holders as before.
 Screw the strain relief of the mains cable back in place.
 Insert the mains plug into an electrical socket. The control unit LED must light up
green.
 Carry out an electrical measurement in accordance with Chapter 6.2!
 Test the function of the power adjustments!