Page 7
TU3QF-EZ ADJUSTMENTS & OPTIONAL SETTINGS
P1864
33030 082901
P2174
ADJUSTING BREW VOLUMES
IMPORTANT -
Tank
must
be full and refill solenoid shut off prior to making these adjustments.
Sprayhead must be installed while making these adjustments.
INCREASING THE BREW VOLUME:
Use the following steps when you want to increase the amount of water for
each brew cycle.
1. Place a funnel in the funnel rails and an empty container of at least four gallons beneath the funnel.
2. Turn ON the brewer.
3. Press and hold the brew start switch until you hear the brew solenoid click on-and-off three times (approxi-
mately 5 seconds). Release the switch.
4. Momentarily press and release the brew start switch once for each two seconds to be added to the prior
setting.
5. Allow the cycle to finish.
The brewer is now set to dispense this amount of water for each subsequent brew cycle.
DECREASING THE BREW VOLUME:
Use the following steps when you want to decrease the amount of water for
each brew cycle.
1. Place a funnel in the funnel rails and an empty container of at least 4 gallons beneath the funnel.
2. Turn ON the brewer.
3. Momentarily press and release the brew start switch once for each two second period to be removed from
the prior setting.
4. Press and hold the brew start switch until you hear the brew solenoid click on-and-off three times (approxi-
mately 5 seconds). Release the switch.
5. Allow the cycle to finish.
The brewer is now set to dispense this amount of water for each subsequent brew cycle.
