Page 16
MUST GRIND INTO
FUNNEL FIRST
(RECIPE NAME)
SETUP COMPLETE
BEGIN SETUP OF
(RECIPE NAME)
QUIT SETUP?
YES
INSERT FUNNEL
WITH NEW NAME
REVIEW RECIPES?
NO YES
(RECIPE NAME)
NO YES
BATCHES DONE?
NO YES
SET NEW RECIPE?
NO YES
2 SEC.
CYCLES THROUGH
TWO SCREENS
FUNNEL
CONTAINS NAME
FUNNEL CONTAINS
NO NAME
SETUP BREW VOLUMES, DILUTION, PULSE BREW,
PREINFUSION, DRIPOUT TIME
SEE SEPARATE DIAGRAMS
FOR SETUP INSTRUCTIONS
P3205
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
Procedure for Setting the Recipe:
NOTE:
Before beginning setup, place a GPR server
beneath the sprayhead.
1. Insert the funnel into the grinder and select a batch
size to grind. It is not necessary to have coffee
beans in the hopper(s) in order to program the
brewer. The coffee name is pre-selected and stored
in the grinder's memory for the side being ground.
2. Press the "GRIND" pad. When the grinder stops
grinding, remove the funnel.
3. On the brewer, press and hold the ® pad until the
display reads
WARMER OFF.
Press the ® pad
until the display reads
SET NEW RECIPE.
Release
the ® pad.
4. Press and release
YES
. The display should read
INSERT FUNNEL WITH NEW NAME
, then
QUIT
SETUP?
These two displays will repeatedly cycle.
5. Insert the funnel into the rails of the brewer. The
display should read the
NAME
of the coffee that
was ground into the funnel, along with a
NO
and
YES
. If the
NAME
on the display is correct, press
YES
.
6. If, for some reason, the name of the coffee from
the grinder did not load properly into the funnel, or
if a grind has not yet been done, the display will
read
MUST GRIND INTO FUNNEL FIRST.
It will be
necessary to grind another batch following steps
1 and 2.
7. If the grind is acknowledged by the brewer, the
display will read
BEGIN SETUP OF (RECIPE NAME)
.
Then the screen will display
BREW MI
. and a batch
light will be blinking. (Refer to page 22 for descrip-
tion of
BREW Ml.
function).
SET NEW RECIPE - METHOD 1
Using a Smart Funnel and a Single Multi-BrewWISE
DBC Grinder:
This function allows the operator to set
BREW
VOLUMES, DILUTION PERCENTAGES, PULSE BREW
TIMES, PREINFUSION TIMES
and
DRIP-OUT TIMES
for each coffee name preset in the grinder's memory.
Certain coffee
NAMES
are stored in the MULTI-
BREWWISE DBC Grinder's memory. When a particu-
lar name of coffee is ground into the Smart Funnel, that
name and the batch size selected are transferred from
the grinder to the programming
chip
located in the
funnel handle. The funnel is then inserted into the
brewer's left side funnel rails. The sensor coil on the
brewer reads the information contained in the handle.
The name of the coffee flavor will then appear on the
display. This then allows the operator to set the
BREW
VOLUMES, DILUTION PERCENTAGES, PULSE BREW
TIMES, PREINFUSION TIMES
and
DRIP-OUT TIMES
for that particular coffee
NAME
. It also allows the
operator to set other brewing parameters, such as
BREW TEMPERATURE, READY TEMPERATURE,
BREW LOCKOUTS,
etc. Each coffee
NAME
can be set
individually to provide optimum brewing quality.
BREW MI. XX.X
(-) DONE (+)
% DILUTION: XX
(-) DONE (+)
BATCHES DONE?
NO YES
P3206
37467 110904
