Bulteh 2000 SMART EBULLIOMETER, User Manual, Page: 46 / 48

18 Measured heater voltage in active state and relay turned off is under minimum value
19 Measured heater voltage in passive state is over maximum value
20 Measured heater voltage in passive state is under minimum value
21 Error in heater current measurement test
22 Dangerous high temperature of the power block.
23 Heater temperature is over maximum value
24 Heater temperature in the start of the measurement is over maximum value
25 Heater temperature is under minimum value
26 The time while the heater is powered with high power is too long
27 Heater temperature while the heater is powered with low power is over maximum value
28 Heater current is over maximum value
29 Power block temperature under minimum specified value
30 Power block temperature over maximum specified value
6.8. Description of error group 7 : EEPROM related errors
Code Description
1 EEPROM initialization error
6.9. Description of error group 8: System timers related errors
Code Description
1 Wrong event handler
2 Timer ID is out of range
6.10. Description of error group 9: Atmospheric pressure sensor related errors
Code Description
1 Wrong ID
2 Wrong structure
3 Device not found
4 Invalid length
5 Communication error
6 Invalid mode
7 Bond wire error
8 Implausible temperature
9 Implausible pressure
10 Calibration parameter is out of range
11 Uncompensated temperature is out of range
12 Uncompensated pressure is out of range
13 Uncompensated temperature and pressure are out of range
14 Uncompensated data cannot be calculated
15 Error in the 32-bit temperature representation
16 Error in the 32-bit pressure representation
17 Error in the 64-bit pressure representation
18 Temperature representation error in double-precision format
19 Pressure representation error in double-precision format
20 Conversion time is out of the limit
21 Pressure value is under minimum value
22 Pressure value is over maximum value
23 Temperature value is under minimum value
24 Temperature value is over maximum value
25 The pressure change value is over the maximum value
26 The temperature change value is over the maximum value
27 Calibration value checksum error
28 Calibration value is out of range
29 Invalid ODR/OSR settings